Alabama Oversize Permits Alabama Oversize and Overweight Permits phone number: (630) 800-4551. Alabama Oversize and Overweight Permits
In Alabama, vehicles or freight that exceed the permissible weight or dimension restrictions are considered oversize or overweight and must be carried in accordance with the law. These limitations are intended to ensure road safety, keep critical infrastructure, and decrease the likelihood of accidents or damage to roads and bridges. These loads are classified into three categories: oversize, overweight, and overhang. To lawfully move oversize loads, Alabama Oversize Permits must be obtained from the Alabama Department of Transportation (ALDOT). These permits guarantee that all regulatory restrictions are met while keeping the load, other road users, and infrastructure. Transporting loads that exceed legal limits without sufficient permits may result in penalties, delays, and damage to roads, bridges, and other vehicles.
Oversized and Overweight Regulations in Alabama
According to Alabama law, any load that exceeds the stated weight and dimension restrictions is considered oversize or overweight.
Legal size limit:
Width: 8’6″ (8′ for routes less than 12 feet wide, measured from the outermost points of the vehicle or load, excluding safety equipment)
Height: 13’6″ (measured from the road surface to the vehicle or load’s highest point)
Single Vehicle Length: 40 feet (measured from the front most point of the vehicle or load to the rearmost point).
Truck and Semi-Trailer Length: 57 feet (measured from the front most point of the vehicle or load to the rearmost point).
Overhang: 5 feet.
Legal weight limit:
Maximum Gross Weight: 80,000 lbs. (with the load)
Steering Axle weighs 20,000 pounds.
Single Axle: 20,000 pounds.
Tandem Axle: 34,000 pounds.
Alabama Single Trip Oversize/Overweight Permits
A general single-trip permit is offered for non-divisible load that exceed the legal size or weight restrictions. This permit is valid for five days and covers one round travel (from A to B and back). Extensions will only be given if the trip is delayed due to natural disasters.
Alabama Annual Oversize/Overweight Permits
To get an annual permit for oversize or overweight load, you must meet the following requirements:
The maximum length for an empty vehicle or one pulling a load is 75 feet.
The maximum width is 12 feet.
Maximum height is 14 feet.
Maximum Gross Vehicle Weight (GVW): 150,000 lbs.
Single axle weight limit: 22,000 lbs.
Annual permits are vehicle-specific, requiring that the Vehicle Identification Number (VIN) on the permit match the VIN of the licensed vehicle.
Alabama Wide Load Requirements
If your load is wider than 8 feet 6 inches (or 8 feet on roadways smaller than 12 feet), you must get an oversized permit from the Alabama Department of Transportation.
Flagging Requirements for Oversized Loads
An oversize loads corners must be marked with an 18-inch square flag in either red or neon orange.
Requirements for Oversized Load Banners:
Vehicles transporting oversize load must carry "oversize load" flags.
Signs Requirements for Oversized Loads
Signs must be 7 inches wide and 18 inches tall, with 10 letters and a brush stroke width of 1.4 to 1.5 inches.
Lighting Requirements for Oversized Loads:
Oversized trucks are not allowed to have warning lights, although escort vehicles may be forced to have them.
Escort Requirements for Oversized Loads in Alabama
Width Requirements: A front escort vehicle is necessary for loads ranging from 12 to 14 feet wide. On multilane roadways, a rear escort vehicle is also required. Loads that surpass 14 feet in width require both a front and rear escort vehicle.
Height Requirements:
Loads up to 15 feet 6 inches require a front escort vehicle.
Length Requirements:
A front escort vehicle is necessary for weights between 90 and 125 feet long. If the load measures between 125 and 150 feet in length, a rear escort vehicle is required.
Loads that are longer than 150 feet require two law enforcement escorts.
Extension Requirements:
If the load exceeds 5 feet, a rear escort vehicle is necessary.
If the load extends more than 10 feet to the front, a front escort vehicle is necessary.
Alabama Wide Load Restrictions
General Width Limit:
Loads above 8′ 6″ must adhere to the following criteria.
Holiday Restrictions:
Oversize load cannot move unless stated in permits.
- Sundays
- New Year’s Day
- National Holidays.
Legal travel times for oversized loads are from half an hour before sunrise to half an hour after sundown.
Road and Bridge limitations:
Alabama uses the Federal Bridge Formula for bridge limitations.
Road limitations include driving past construction work zones and ignoring warning flags.
Not prioritizing police enforcement, emergency vehicles, and so forth.
Seasonal Weight limitations:
While the Frost Law is applicable in many states and Canadian provinces, Alabama does not have special seasonal limitations. Such limits may, however, be incorporated in oversize load permits, depending on the nature and kind of load.
Alabama Wide Load Limits
General Width restriction:
Alabama keeps to the Federal legal width restriction of 8’6″. Any weight larger than this needs a permit to be moved on public roadways.
Maximum load limits without permit:
General width limit: 8’6″ – For highways less than 12′ wide: 8′ (measured from the outermost points, excluding safety devices).
Axle Weight Limitations:
Legal axle weight limit:
Single axle capacity is 20,000 lbs, while tandem axle capacity is 34,000 lbs.
General Rule: Weight equals 500 (LN/ (N-1) + 12N + 36), where N is the number of axles and L is the
Distance in feet between the extremes of any set of successive axles.
The Maximum Permitted Axle Weight Limit:
Single axle: 22,000 lbs (may vary by permission).
Oversized Tire Regulations:
Tires must be in good working order, fully inflated, and with a minimum tread depth of 2/32″.
Protuberances made of any material other than rubber are not permitted on tires unless absolutely necessary for safety.
Each tire must have a rubber surface that covers the whole grip area, is at least four inches wide, and extends at least one inch above the rim edge all around.
Licensing Requirements for Interstate Operations
IFTA Fuel Permits: Required for cars crossing state boundaries.
You must have an IFTA fuel Permit and decal.
- IRP License Plate and Cab Card: Required for interstate transportation.
Alabama Specialty Permits.
Special Permits required dependent on load type, size, and weight.
Truck Permit Service
Overweight permit provides complete trucking permit services, assisting motor carriers in obtaining the essential oversize and overweight permits. We collaborate closely with authorities to guarantee compliance with state requirements, saving you time and effort while avoiding any penalties. We can assist you regardless of the kind, nature, or destination of your load.
To apply for an Alabama Oversize Permits, trucking companies and carriers may contact Overweight Permit at (630) 222-5770. Our staff has vast experience assisting customers through the process of obtaining Alabama DOT permits while remaining compliant with all state standards. If you need ALDOT Truck permits, Alabama Oversize permits cost estimates, or help with Alabama Oversize permit login, we are here to help make the process as efficient and simple as possible.
FAQs
Alabama Oversize and Overweight Permits are required for transporting vehicle or loads that exceed the weight or dimension limits established by Alabama law. These permits promote road safety and infrastructure protection.
Width: 8’6″ (8′ for roads less than 12 feet wide)
Height: 13’6″
Single Vehicle Length: 40 feet
Truck and Semi-Trailer Length: 57 feet
Overhang of 5 feet
Maximum Gross Weight: 80,000 lbs (with load)
Steering Axle: 20,000 lbs
Single Axle: 20,000 lbs
Tandem Axle: 34,000 lbs
A single-trip permit is valid for five days and allows for one round travel of non-divisible load that exceed legal size or weight limits. Extensions are only permitted for delays caused by natural catastrophes.
The vehicle cannot exceed:
Dimensions: 75 feet long, 12 feet wide, and 14 feet tall. – Gross vehicle weight: 150,000 lbs. – Single axle weight: 22,000 lbs.
The corners of the oversize load must be marked with an 18-inch square flag in red or bright orange.
Vehicles must have “oversize load” flags.
Signs must be 7 inches wide by 18 inches tall, with 10-inch letters and brush stroke widths of 1.4 to 1.5 inches.
Width: Front escort for loads 12-14 feet wide, and both front and rear escorts for loads beyond 14 feet.
Height: Front escort for loads up to 15’6″.
Length: Front escort for loads 90 to 125 feet; rear escort for loads 125 to 150 feet; and two law enforcement escorts for loads greater than 150 feet.
Extension: Rear escort for loads longer than 5 feet; front escort for loads longer than 10 feet in front.
Oversized loads are not permitted to travel on Sundays, New Year’s Day, or national holidays unless specifically indicated in the permit. Legal travel periods range from half an hour before sunrise to half an hour after sunset.
To apply for an Alabama Oversize Permits, call Overweight Permit at (630) 222-5770. They offer complete trucking permit services to ensure compliance with state regulations.
Overweight Permit simplifies the permit application procedure by managing all documentation and interactions with authorities. Our experience provides a speedy and effective permit acquisition, allowing trucking businesses to concentrate on their main activities.
Yes, we can help with urgent permit requests. Our staff is prepared to manage unexpected scenarios and speed the permit application procedure, reducing delays and keeping your operations operating smoothly.
We provide specialized customer service to meet all of your permit-related requirements. Our skilled team is here to answer your concerns, give direction, and ensure that your trip runs smoothly from beginning to end.
The Overweight Permit streamlines the permit application process by handling all documents and communications with authorities. Our competence ensures a quick and efficient permit acquisition, allowing transportation companies to focus on their primary tasks.
Yes, we can assist with urgent permit requests. Our crew is ready to handle unforeseen situations and expedite the permit application process, eliminating delays and keeping your operations running smoothly.
We offer customized customer assistance to fulfill all of your permit-related needs. Our trained team is available to address your issues, provide guidance, and ensure that your trip works well from start to finish.
To get started, call us at (630) 222-5770. To guarantee a flawless experience, our staff will review your needs, offer a full explanation of our services, and walk you through the permit application process.
